1997 > 1997
1. Locate the RKE programming
connector in the rear trunk/boot area.
2. It should have 2 connections
and should not be plugged into anything else, and removal of
the vehicle trim maybe necessary.
3. Connect the 2 terminals together
using a suitable jumper cable or connection.
4. The Remote Keyless Entry module will cycle the locks from LOCK to UNLOCK to confirm programming mode.
5. PRESS and HOLD the LOCK and UNLOCK button on the first remote transmitter to be programmed for
at least 15 Seconds or until the
vehicle LOCKS and UNLOCKS the doors.
6. The doors will cycle LOCK to UNLOCK to confirm programming.
7. Repeat for any additional remote transmitters.
8. REMOVE the jumper from connector.
9. Check all remote transmitters for operation.