1991 > 1994
1. Insert key into ignition and switch ON.
2. Locate the VAC programming
connector located near the RKE
module.
3. It is a GREEN connector with
1 wire and not connected to anything.
4. GROUND the terminal to a suitable ground connection using a wire.
NOTE : Once the terminal has
been connected to GROUND, the
procedure MUST be completed within 30 seconds. If not start again.
5. The doors will LOCK and UNLOCK to confirm programming mode.
6. PRESS the UNLOCK button the first
remote transmitter to be programmed TWICE
pausing for 1 second between each press.
7. The doors will LOCK and UNLOCK to confirm programming.
NOTE : ALL existing remote
controls will be deleted when programming starts.
NOTE : The system requires 2 remote transmitters to be programmed,
so if you only have one transmitter then repeat steps 6 and 7 again with the
same transmitter.
8. To program additional remote transmitters repeat steps 6 and 7 for the additional remote transmitters.
9. Remove ground connection from programming connector.
10. Test all remote transmitters for operation.