1995 > 1997
NOTE : To perform this procedure the FAN UP (YES) and FAN DOWN (NO) buttons will
need to be pressed as required.
1. INSERT the key into the ignition and switch ON.
2. PRESS the OFF (MAIN CLIMATE CONTROL) and WARM (PASSENGER CLIMATE CONTROL) buttons together.
3. The IPC will light and then
go blank to indicate diagnostic mode.
4. The digital display near the odometer will display a number of rolling
codes, please wait until it stops.
5. PRESS the FAN DOWN button until RFA is
displayed on the panel.
6. PRESS FAN UP to select this option.
7. If RFA CODES ? is
displayed PRESS the FAN DOWN button.
8. If RFA DATA ? is
displayed PRESS the FAN DOWN button.
9. If RFA OVERRIDE is displayed PRESS
the FAN UP to select this option.
10. If RFA S00 NO OVERRIDE
is displayed PRESS the FAN DOWN button.
11. If RFA S01 PROGRAM FOB 1 is displayed.
12. The main console will
display 0,
toggle the WARM button on the
passenger climate control panel unit 99
is displayed.
13. PRESS and HOLD the
trunk/boot button on the remote transmitter which has a 1 on the rear, and within 1 second PRESS and HOLD the LOCK.
14. Continue to HOLD the buttons until the LOCKS cycle or the display changes from
99 to 0.
15. To program the next remote
transmitter PRESS the FAN DOWN button until RFA S02 PROGRAM FOB is
displayed.
16. Repeat steps 12 to 14 to program the second remote transmitter.
17. PRESS any of these buttons AUTO,
MODE UP, MODE DOWN or REST to exit.
18. Check all remote transmitters for operation.
NOTE : If a remote transmitter is not programmed within 30 seconds the display
will change to 0 to indicate programming mode has ended.