1997 > 1999
1. Locate the RKE programming
connector in the rear trunk/boot area.
2. It should have 1 connection
with one BLACK/WHITE wire and should
not be plugged into anything else, and removal of the vehicle
trim maybe necessary.
3. Connect the terminal GROUND
using a suitable jumper cable or connection.
4. The Remote Keyless Entry module will cycle the locks from LOCK to UNLOCK to confirm programming mode.
5. PRESS the UNLOCK button for 10 seconds on the first remote
transmitter to be programmed or until the locks cycle.
6. The doors will cycle LOCK to UNLOCK to confirm programming.
7. Repeat for any additional remote transmitters.
8. REMOVE the jumper from connector.
9. Check all remote transmitters for operation.