1993 > 1996
1. Switch Ignition ON.
2. Locate the RKE programming
connector in the rear trunk/boot area driver side.
3. It should have 1 connection
with one BLACK/WHITE wire and should
not be plugged into anything else, and removal of the vehicle
trim maybe necessary.
4. Connect the terminal GROUND
using a suitable jumper cable or connection.
5. The Remote Keyless Entry module will cycle the locks from LOCK to UNLOCK to confirm programming mode.
6. PRESS the ANY button on the first
remote transmitter to be programmed.
7. The doors will cycle LOCK to UNLOCK to confirm programming.
8. Repeat for any additional remote transmitters.
9. REMOVE the jumper from connector.
10. Check all remote transmitters for operation.