WITH KEYLESS ENTRY SYSTEM

1. CONFIRM all doors are CLOSED.

2. Ensure drivers door is UNLOCKED.

3. Insert emergency key into ignition switch. DO NOT switch ignition ON.

Within 25 seconds:

4. PRESS central locking switch on drivers door 3 times to LOCK then UNLOCK position.

5. PRESS central locking switch on drivers door to LOCK position.

6. REMOVE and INSERT emergency key into ignition switch 4 times.

START engine and leave running for at least 3 seconds.

Within 60 seconds:

7. Switch ignition OFF.

8. An audible warning will sound twice.

9. Doors UNLOCK to confirm programming mode active.

Within 30 seconds:

10. PRESS any button on remote control to be programmed.

11. An audible warning will sound twice.

12. Doors LOCK and UNLOCK to indicate correct programming.

13. REPEAT above procedure to program additional remote controls.

14. To EXIT programming mode switch ignition OFF and remove emergency key.

WITHOUT KEYLESS ENTRY SYSTEM

1.    CONFIRM that all doors are CLOSED and ignition key is OUT of ignition.

2.    OPEN driver side door.

3. Turn ignition switch to ON position, and then remove ignition key from ignition within 10 seconds.

4. Push and release driver side Door Open Sensor switch 3 times by hand within 20 seconds after removing ignition key.

5. Turn ignition switch to ON position, and then remove ignition key from ignition key cylinder within 10 seconds.

NOTE : All doors automatically lock and unlock once. It is now in registration mode.

6. Press UNLOCK button on the transmitter within 20 seconds after Step 5.

NOTE : All doors automatically lock and unlock once. Now transmitter registration is completed.

7. If an additional transmitter needs to be programmed repeat the procedure from Step 1.

NOTE : This procedure needs to be performed very quickly.

NOTE : It is understood that only 2 remotes can be programmed in. If a third is added, the first will be forgotten.