2007 > 2012
FORD REMOTE
– THIS PROCEDURE RESETS ALL REMOTES FOR THE VEHICLE. ALL FUNCTIONING
REMOTES WILL HAVE TO BE REPROGRAMMED DURING THE PROCEDURE
Make sure that you do not
press the brake pedal at any time during or before the procedure.
Procedure A:
1.
CLOSE
all doors, then OPEN drivers door
and PRESS the UNLOCK button on drivers door while it is OPEN.
2.
INSERT
key into ignition.
3.
SWITCH
ignition from OFF to ON 8
times within 8 seconds, with the 8th time ending in ON.
4.
Door locks will CYCLE to confirm programming mode. (If
the door locks do not cycle, then it was done incorrectly. You must start over
by removing key and beginning from step 1)
NOTE :
Off is the position where you can remove your key, ON is the position before
starting your car.
5.
WITHIN
10 seconds PRESS any button on the first keyless remote to be programmed. Door
locks will CYCLE to confirm
programming.
6.
REPEAT
step 5 for any additional remotes.
If you only have one remote then skip to step 7.
7.
Turn ignition to OFF. Locks will again cycle to indicate
end of programming mode.
NOTE
: If this does not work try the procedure with the door
closed.
Procedure B:
1.
FASTEN
seatbelt and CLOSE all doors.
2.
SWITCH
the ignition from OFF to ON 4
times within 3 seconds.
3.
Turn the ignition OFF. The system will CHIME to confirm programming mode.
4.
WITHIN
10 seconds, press and hold any
button on first keyless remote. The system will chime once to confirm
programming.
5.
REPEAT
step 4 for all additional remotes.
6.
SWITCH
ignition to ON to exit programming
mode.