2007 > 2007
NOTE : Make sure the drivers
door is open and unlocked and Key is out of the ignition.
1. INSERT and REMOVE the key from the
ignition key cylinder twice within 5 seconds.
2. CLOSE and OPEN the drivers door twice within 40 seconds.
3. INSERT the key into the ignition and remove it, do not turn.
4. CLOSE and OPEN the drivers door twice within 40 seconds.
5. INSERT the key into the ignition.
6. CLOSE the door.
7. Turn the ignition switch from LOCK
to ON and back to LOCK at about 1 second intervals
to select the desired mode :
NOTE : 1 time for ADD.
NOTE : 2 times for REWRITE.
NOTE : 3 times for CONFIRMATION.
NOTE : 5 times for PROHIBITION.
8. Remove the key from the ignition.
NOTE : To confirm your
selection of all modes except CONFIRMATION,
the power locks
will now cycle LOCK to UNLOCK a number of times corresponding
the mode selected.
NOTE : If CONFIRMATION mode has been selected, the power door locks will now
cycle
in 2 seconds intervals) a number of times corresponding to the number of
transmitters currently registered.
Opening the door will complete the procedure.
NOTE : If PROHIBITION mode has been selected, opening the door will complete
the procedure.
11. For ADD or REWRITE modes,
within 20 seconds of Door Lock
confirmation proceed as follows :
(a) Press both transmitter LOCK and UNLOCK buttons simultaneously between 1 and 1.5 seconds and
release.
(b) Within 3 seconds of step (a),
press the transmitter LOCK button
for more than 1 second and release.
(c) If the transmitter has been
successfully programmed, the power locks will cycle LOCK to UNLOCK
once at this time. If there are problems with the procedure up to this
point, the locks
will cycle twice, in which case you must go back and repeat the above steps
(a) and (b).
(d) If multiple transmitters are to
be programmed, repeat the above steps (a) to (c).
12.
Open the drivers door to complete the procedure.