2002 > 2009
PROCEDURE
1
1. Switch Ignition ON and leave
the key in the ignition.
2. Mechanically lock the vehicle using the drivers
door using a second key.
3. Using the remote control, press the UNLOCK
button once, and the horn will sound.
4. Wait 10 seconds and press the
UNLOCK button once to activate the
coding procedure.
NOTE : When programming
additional remotes the procedure is the same, except you press the UNLOCK button :-
2
times for remote control number two.
3
times for remote control number three.
4
times for remote control number four.
5. Switch Ignition OFF.
6. REMOVE key from ignition and check for operation.
7. The coding procedure can be repeated up to 4 times for additional
remotes.
8. The ignition must be switched OFF
between programming each remote control.
PROCEDURE
2
1. Switch ignition ON (do not
start).
2. INSERT a second
key in the drivers door lock.
3. Turn to the UNLOCK position
(anticlockwise)
and hold until it beeps three times, about 10-15
seconds, then return to center
position (leave in the lock).
4. Then PRESS one of the remote
control buttons (if programming more than one remote control, press each remote
once to program)
5. The HORN will beep for
each remote control programmed (1
beep for remote control number one, 2 for remote control number 2 etc)
6. Then TURN the door key
back anticlockwise until the horn beeps three times to
deactivate
programming mode, and remove the ignition key.
7. Test all remote controls.