DENSO RKE SYSTEM

NOTE : Receiver module is the ETACS module on the back of the fuse block, left hand side of dash.

NOTE : Maximum 4 transmitters can be programmed, and must be programmed at the same time.

1.    Insert the key into ignition. DO NOT turn.

2.    With ignition OFF connect pins 1 and 4 of the OBD socket with a suitable jumper.

NOTE : OBD Diagnostic locations can be found here www.wikiobd.co.uk

3.    Within 10 seconds of connecting the diagnostic tool, press the HAZARD switch 6 times.

4.    The doors should LOCK and UNLOCK to confirm programming mode.

5.    Press any button on the first remote transmitter slowly 3 times within 10 seconds.

6.    The doors should LOCK and UNLOCK to confirm remote transmitter is programmed.

7.    Press any button on the second remote transmitter slowly 3 times within 10 seconds.

8.    The doors should LOCK and UNLOCK to confirm remote transmitter is programmed.

9.    Repeat for third and fourth remote transmitters as required.

10. Remove Jumper from OBD socket.

11. Remove Ignition key and test all remote transmitters for operation.