1. Open boot /trunk and leave OPEN.

2. OPEN driver's door and leave OPEN.

3. Turn ignition switch ON.

4. PRESS valet switch 5 times. A sound and flash of the headlights indicates the vehicle has entered the PROGRAM mode.


NOTE : Valet switch is located in the centre console.

5. Press the ALARM/LOCK button of the first REMOTE CONTROL, within 15 seconds of the system entering PROGRAM mode.

NOTE : The ALARM/LOCK is the larger button.

NOTE : This first remote control will be linked to position 1 of the
 seat/steering/mirror memory, 2^nd remote to position 2 etc etc.

NOTE : A sound will confirm that the
 remote control has been programmed.



6.  PRESS the valet switch ONCE.

NOTE : Two sounds will be heard to indicate system is ready for 2^nd REMOTE CONTROL.

7. Press the ALARM/LOCK button of the 2^nd REMOTE CONTROL.

NOTE : Two sounds will confirm that the
 remote control has been programmed.

8. Repeat steps 6 and 7 for up to a total of 5 remote controls.

NOTE : If you have less than 5 remote controls, you MUST still repeat this procedure 5 times using the last remote control more than once.

9. Switch ignition OFF and close door and boot/trunk.


10. Test all remote controls and memory functions are working and correct.