1.    CLOSE all doors.

2.    INSERT key into ignition.

3.    Hold down the power UNLOCK button on the driver's door panel until instructed to release in step 9.

4.    Perform steps 5 through 8 quickly.

5.    Turn the ignition to the ON position (do not start the engine.)

6.    Turn the ignition to the OFF position.

7.    Turn the ignition to the ON position (do not start the engine.)

8.    Turn the ignition to the OFF position.

9.    Release the power UNLOCK button on the door panel.

NOTE : The door locks should LOCK and UNLOCK.

10. HOLD down the LOCK and UNLOCK buttons on the remote control key until the doors LOCK and UNLOCK.

NOTE : This may take up to 30 seconds.

11. Repeat step 10 immediately for each additional remotes and all existing remote controls.

12. Turn the ignition to the ON position to exit the programming mode.

13. Test all remote transmitters for operation.