2002 > 2007
REMOTE
CONTROL REGISTRATION
NOTE :
All transmitters will need to be obtained from the customer as all transmitters
(new or existing) are programmed at one time. If a transmitter is not
programmed during this procedure, it will become inoperative.
NOTE :
On 2006 model year MX-5 Miata and Mazda5, two types of keyless entry systems
have been introduced, each having a different procedure for registering
transmitters. To identity which type applies, perform the following steps:
1. Remove key from steering lock and CLOSE
all doors and boot or trunk.
2. OPEN driver side door.
3. INSERT key into steering lock.
4. Repeat the following three times:
5. SWITCH ignition switch to ON
position, then back to LOCK
position.
6. CLOSE and CLOSE driver side door
three times (then leave the door open)
7. CLOSE the driver side door.
8. Do the lock actuators perform the LOCK
UNLOCK cycle TWICE.
NO : TYPE
A system.
YES : TYPE B system.
TYPE
A PROCEDURE
1. REMOVE key from ignition.
2. CLOSE all doors and boot/trunk.
3. OPEN drivers door.
4. INSERT key into ignition, then switch ignition ON and back to LOCK 3 times.
5. Leave key in ignition.
6. CLOSE and OPEN drivers door 3 times and then leave door OPEN.
7. The door locks should LOCK
and UNLOCK to confirm programming
mode.
8. PRESS the UNLOCK button on the
first remote transmitter 2 times.
9. The door locks should cycle LOCK
to UNLOCK to confirm programming.
10. Repeat step 8 and 9 for any
additional remote transmitters.
11. Check all remote
transmitters for operation.
TYPE
B PROCEDURE
1. REMOVE key from ignition.
2. CLOSE all doors and boot/trunk.
3. OPEN drivers door.
4. INSERT key into ignition, then switch ignition ON and back to LOCK 3 times.
5. Leave key in ignition.
6. CLOSE and OPEN drivers door 3 times and then leave door OPEN.
7. The door locks should LOCK
and UNLOCK to confirm programming
mode.
8. PRESS ANY button on the first
remote transmitter 2 times.
9. The door locks should cycle LOCK
to UNLOCK to confirm programming.
10. Repeat step 8 and 9 for any
additional remote transmitters.
11. Check all remote
transmitters for operation.
NOTE : Always program three remote transmitters
as the programming mode terminates after 3 remote transmitters are programmed.
The same programmed transmitter can be programmed two or three times to allow
the three memory slots to be programmed.
NOTE : A maximum of three remote transmitters can be programmed.
NOTE :
When programming the remote, verify that other transmitters are not being
operated in the vicinity.
NOTE :
If a button other than the transmitter UNLOCK
button is operated, the programming operation is disabled and the programming
mode is cancelled.