1.    Use a jumper wire and connect between terminals 11 and 12 of the 20 pin diagnostic connector, located in the engine compartment close to the battery.

NOTE : DO NOT user the 12 Pin OBD connector, otherwise you will damage the vehicle systems.

2.    Switch ignition ON.

3.    Decided how many remote transmitters are to be programmed.

PROGRAMMING 1 REMOTE TRANSMITTER

4.    PRESS and HOLD the LOCK button on the remote transmitter to be programmed until the signal indicator lamps FLASH TWICE.

5.    GO to STEP 8.

PROGRAMMING 2 REMOTE TRANSMITTERS

6.    PRESS and HOLD the LOCK button on the first remote transmitter for 1 second, until the indicator lamps FLASH ONCE.

7.    PRESS and HOLD the LOCK button on the second remote transmitter for 1 second, until the indicator lamps FLASH ONCE.

8.    Switch ignition OFF and REMOVE key.

9.    Remove jumper wire.

10. Check all remote transmitters for correct operation.

NOTE : Maximum 2 remote transmitters can be programmed.