2002 > 2006
1. Use a jumper wire and connect between terminals 16 and 12 of the 20 pin diagnostic connector, located in
the engine compartment close to the battery.
NOTE : DO NOT user the 12 Pin OBD connector, otherwise you will
damage the vehicle systems.
2. Switch ignition ON.
3. PRESS the LOCK button on the first
remote transmitter to be programmed 2
times.
4. PRESS the LOCK button on the
second remote transmitter 2 times.
5. Switch ignition OFF and REMOVE key.
6. REMOVE jumper wire.
7. Check all remote transmitters for correct operation.
NOTE : Maximum 2 remote
transmitters can be programmed.