1.    Use a jumper wire and connect between terminals 16 and 12 of the 20 pin diagnostic connector, located in the engine compartment close to the battery.

NOTE : DO NOT user the 12 Pin OBD connector, otherwise you will damage the vehicle systems.

2.    Switch ignition ON.

3.    PRESS the LOCK button on the first remote transmitter to be programmed 2 times.

4.    PRESS the LOCK button on the second remote transmitter 2 times.

5.    Switch ignition OFF and REMOVE key.

6.    REMOVE jumper wire.

7.    Check all remote transmitters for correct operation.

NOTE : Maximum 2 remote transmitters can be programmed.