1.    LOCATE the security system ECU mounted under the drivers seat.

2.    Under the label on the top of the ECU, there is a hole, which is hiding a yellow programming button.

3.    SWITCH ignition ON then OFF.

4.    PRESS and HOLD the YELLOW programming button.

5.    The security system will sound 4 chirps and then a burst of 5 chirps to confirm programming mode.

6.    The system will then sound every 3 seconds.

7.    RELEASE the programming button.

8.    AFTER the chirps sound, PRESS the LOCK button on the remote transmitter to be programmed.

9.    The system will CHIRP to confirm success.

10.  If you wait too long to program the remote transmitter the system will EXIT programming mode.

11.  To program additional remote transmitters, wait for the next CHIRP sounds, and repeat STEP 8 and 9.

12.  To EXIT programming SWITCH ignition ON then OFF.

13.  CHECK all remote transmitters for operation.

NOTE : Maximum 4 remote transmitters can be programmed.