NOTE :  OPEN the glove box. Locate the keyless entry program line - a dark green wire with a molded plastic insulator on the end. The program line is located behind the lower end of the glove box.

1.    CONNECT the program line from the Remote Keyless Entry Module to ground with a suitable jumper wire.

2.    INSERT the key into the ignition and switch ignition switch to the ON position.

3.    PRESS any button on the remote transmitter to be programmed.

4.    For a second remote transmitter program it now by pressing any button.

5.    The LOCKS will LOCK and UNLOCK to confirm programming.

6.    DISCONNECT the program line from ground.

7.    SWITCH ignition OFF and remove key.

NOTE : If you cannot find the Jumper Plug locate the Keyless Module behind the Glove Box
. It should have 2 plugs
. Find the 8 Pin Plug with Green wire and 
JUMPER Green wire to Ground.